ROTATIONAL MOLDING - Costing Expert

Input Section

Rotational Molding

A) General Part Information

Part Number:

Part Description:

B) Volume Impact

Annual Volume:

Lot Size:

C) Minimum required input

Application:

Part Length(mm) - L

Part Thickness (mm) - T:

Material Net Weight (Lbs):

Enable Key Assumptions & Overrides

# of Inserts:

Average cost of Inserts ($/insert):

Material 1 (Primary Outer Layer):

Rotational Molding Costing Tool

1

Enter Part Information

2

View Estimate

3

Enable Customization (Opt.)

4

Unlock Global costs

5

Save

Rotational Molding,also known as rotomolding is a manufacturing Method used to Make hollow plastic products by heating and rotating a mold. the work involves introducing amp fine polymer matter (typically plastic) into amp hole cast which is extremely hot and turned along aggregate axes. As the mold rotates the heated polymer melts and evenly coats the interior surfaces of the mold.Rotomolding offers cost-effective tooling excellent material distribution and the ability to produce large Complicated and high-quality products with consistent thickness and durability. it is wide old inch industries care moving husbandry structure and consumer commodity.

A) General Part Information

Part Number:-

- Part Number which is usually mentioned on the drawing. (Alphanumeric values are accepted).

B) Volume (Number of Pieces Produced)

Annual Volume:-

- The Number of Pieces that are Required in a Year (Limit set for the tool: 1- 10000000 Nos).

Lot Run Size:-

- The Number of Parts to be Processed in a Single Setup (Limit set for the tool: Less than or equal to Annual volume).

C) Minimum required input: -

Application:-

-Select the application from the dropdown which are as follows: -

Toy:- common Examples are playground equipment, sandboxes, and ride-on vehicles.

Container/ tank:- chemical container, water tank, storage tank etc.

Boat:- Boat

Material handling:- furniture, such as chairs, tables etc.

Industrial & Automotive:- Fuel tank, Road barrier, Coolers etc.

Part Length (mm):-

-Enter the maximum length of the part.(Limit set for the tool is1 – 3000mm)

Part Thickness (mm):-

-Enter the thickness of the part. (Limit set for the tool is 0.8 - 25 mm)

Part Net Weight (Lbs):-

-Enter the net weight of the part.(Limit set for the tool is maximum up to 225 Lbs.)